• Pika@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      24
      ·
      4 months ago

      We call them a Deadman’s cable up here, and sadly they’re still quite frequently used in the northern rural areas because it costs almost $2,000 to have a dedicated bypass switch installed so nobody does it, they just throw the Main and hope they don’t put too much stress on the internal lines.

      Is it legal? Hell no but they do it anyway

      • Omega_Jimes@lemmy.ca
        link
        fedilink
        arrow-up
        17
        ·
        4 months ago

        I did this.
        Is it stupid? Yes. Did it work? Also yes. For the amount of time that we’d have power out, it was just way to easy to throw a breaker and connect it like this just to keep a small heater and a light running. If I had the money at the time I would have loved battery backup/ bypass but this cost $2 and an old cord.

        • Pika@sh.itjust.works
          link
          fedilink
          English
          arrow-up
          5
          ·
          edit-2
          4 months ago

          Especially considering that having a functional stove nowadays skyrockets your insurance. A lot of people used to use wood stoves as the backup heat source if the power went out, we still have one ourselves however it’s “non-functional” , it probably is to be honest it hasn’t been ran for a few years now but it was going to Skyrocket the insurance if we had it listed as a functional Appliance

        • Duamerthrax@lemmy.world
          link
          fedilink
          arrow-up
          3
          ·
          4 months ago

          There are way cheaper ways to have a safe interconnect then those second box systems. There are kits that install a plate next to the main breaker and prevent both the main breaker and the next closest breaker from both being on at the same time. You then setup the second breaker to be your generator inlet. Here’s a DIY version, but there are kits for all major brands.