• subspaceinterferents@lemmy.world
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    Your comment has been my experience. I’ve been a homeowner in the same house for 30 years. We did a remodel after we first arrived. Gotta say we were naive about many things, plumbing fixtures included. Most of our pipe valves were (as you described) those oval knob jobbies. They are simple compression fixtures that screw in for many turns until the valve closes. These are terrible, awful and very bad. Mine suffered corrosion and froze in place. We recently went through another remodel, and among other things, had all new valves installed. This time we used 1/4 turn brass valves. A simple 90 degree turn and the valve is closed. Much less susceptible to corrosion/rot, etc. They cost more during installation, but in the long run you save time, money and sanity.

    • blackbrook@mander.xyz
      link
      fedilink
      arrow-up
      1
      ·
      1 year ago

      The one possible downside is that you should try to be careful to close them slowly to avoid a water hammer effect.