I’m trying to improve the power consumption of my NAS. The 2 (7200 rpm) HDDs I had were using 15W at idle and 5W when spun down. I’m reading a lot of conflicting information about what is lower power between HDD, SSD and NVMe SSD. Eventually I started looking at SATA SSD (please let me know if this is not the most power efficient)

I found this site that shows a benchmark of different SSDs and their average power consumption. I was about to go with WD Red but then I found a YouTube video saying I shouldn’t go with WD for a NAS.

Can you tell me what brand or model you’re using in your homelab that’s power efficient? Ideally I would like 4TB SSD.

Thanks!

  • paraphrand@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    edit-2
    7 months ago

    Huh, that’s unintuitive to me. I remember people talking about too many hard drives in a case using too much power before. Overloading it, etc. 1-2W each would not overload a normal power supply. 🤔

    Did hard drives just quietly get super efficient when I wasn’t paying attention? Or is something else going over my head here?

    • poVoq@slrpnk.net
      link
      fedilink
      English
      arrow-up
      3
      ·
      edit-2
      7 months ago

      There is a huge difference in power-draw between 2.5" 5400rpm HDDs that one would typically find in a laptop and 3.5" 7200rpm HDDs that are often used in servers even at similar storage capacities. The latter typically use 10W each during normal operation and even a bit more during spin-up. But if you want to optimize your NAS for low power consumption you can use those small 2.5" HDDs just fine (of course being aware that these are not built to withstand the same kind of (ab)use as HDDs specifically built for NAS or datacenter use).

      Edit: of course these small drives are not available in more than I think 4TB right now, and if you want to built really large pools of tens to hundreds of TB then the bigger 3.5" HDDs at some point become more power efficient for the same storage space.