Hi guys! I’m going at my first docker attempt…and I’m going in Proxmox. I created an LXC container, from which I installed docker, and portainer. Portainer seems happy to work, and shows its admin page on port 9443 correctly. I tried next running the image of immich, following the steps detailed in their own guide. This…doesn’t seem to open the admin website on port 2283. But then again, it seems to run in its own docker internal network (172.16.0.x). How should I reach immich admin page from another computer in the same network? I’m new to Docker, so I’m not sure how are images supposed to communicate within the normal computer network…Thanks!

  • chiisana@lemmy.chiisana.net
    link
    fedilink
    English
    arrow-up
    6
    arrow-down
    1
    ·
    7 months ago

    Docker inside LXC adds not only the overhead they’d individually add — probably not significant enough for it to matter in a homelab setting — but with it also the added layer of complexity that you’re going to hit when it comes to debugging anything. You’re much better off dropping docker in a full fledged VM instead of running it inside LXC. With a full VM, if nothing else, you can allow the virtual networking to be treated as it’s own separate device on your network, which should reduce a layer of complexity in the problem you’re trying to solve.

    As for your original problem… it sounds like you’re not exposing the docker container layer’s network to your host. Without knowing exactly how you’re launching them (beyond the quirky docker inside LXC setup), it is hard to say where the issue may be. If you’re using compose, try setting the network to external, or bridge, and see if you can expose the service’s port that way. Once you’ve got the port exposure thing figured out, you’re probably better off unexposing the service, setup a proper reverse proxy, and wiring the service to go through your reverse proxy instead.

    • iturnedintoanewt@lemm.eeOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      7 months ago

      Thanks! When I type my LXC’s IP:2283, I get unable to connect. I checked the docker-compose.yml and the port seems to be 2283:3001, but no luck at either. Is there anything that needs to be done on docker’s network in order to…“publish” a container to the local network so it can be seen? Or any docker running with a port can be reached via the host’s IP with no further config? Checking the portainer’s networks section, I can see an ‘immich-default’ network using bridge on 172.18.0.0/16, while the system’s bridge seems to be running at 172.17.0.0/16. Is this the correct defaults? Should I change anything?

      Thanks!